Lably
Skip to content

Cone cell

Photoreceptor cells responsible for color vision made to function in bright light

  • 6 min read
  • 3 chapters

Related on Lably

Through Light, Visual perception and Human

Cones are less sensitive to light than the rod cells in the retina (which support vision at low light levels), but allow the perception of color. They are also able to perceive finer detail and more rapid changes in images because their response times to stimuli are faster than those of rods. In humans, cones are normally one of three types: S-cones, M-cones and L-cones, with each type bearing a different opsin: OPN1SW, OPN1MW, and OPN1LW respectively. These cones are sensitive to visible wavelengths of light that correspond to short-wavelength, medium-wavelength and longer-wavelength light respectively. Because humans usually have three kinds of cones with different photopsins, which have different response curves and thus respond to variation in color in different ways, humans have trichromatic vision. Being color blind can change this, and there have been some verified reports of people with four types of cones, giving them tetrachromatic vision. The three pigments responsible for detecting light have been shown to vary in their exact chemical composition due to genetic mutation; different individuals will have cones with different color sensitivity.

Structure

Classes

Most vertebrates have several different classes of cone cells, differentiated primarily by the specific photopsin expressed within. The number of cone classes determines the degree of color vision. Vertebrates with one, two, three, or four classes of cones possess monochromacy, dichromacy, trichromacy, and tetrachromacy, respectively.

Humans normally have three classes of cones, designated L, M, and S for the long, medium, and short wavelengths of the visible spectrum to which they are most sensitive. L cones respond most strongly to light of the longer red wavelengths, peaking at about 560 nm. M cones respond most strongly to yellow to green medium-wavelength light, peaking at 530 nm. S cones respond most strongly to blue short-wavelength light, peaking at 420 nm, and make up only around 2% of the cones in the human retina. The peak wavelengths of L, M, and S cones occur in the ranges of 564–580 nm, 534–545 nm, and 420–440 nm, respectively, depending on the individual. The typical human photopsins are coded for by the genes OPN1LW, OPN1MW, and OPN1SW. The LMS color space is an often-used model of spectral sensitivities of the three cells of a typical human.

Histology

Cone cells are shorter but wider than rod cells. They are typically 40–50 μm long, and their diameter varies from 0.5–4.0 μm. They are narrowest at the fovea, where they are the most tightly packed. The S cone spacing is slightly larger than the others.

Like rods, each cone cell has a synaptic terminal, inner and outer segments, as well as an interior nucleus and various mitochondria. The synaptic terminal forms a synapse with a neuron bipolar cell. The inner and outer segments are connected by a cilium. The inner segment contains organelles and the cell's nucleus, while the outer segment contains the light-absorbing photopsins, and is shaped like a cone, giving the cell its name.

The outer segments of cones have invaginations of their cell membranes that create stacks of membranous disks. Photopigments exist as transmembrane proteins within these disks, which provide more surface area for light to affect the pigments. In cones, these disks are attached to the outer membrane, whereas they are pinched off and exist separately in rods. Neither rods nor cones divide, but their membranous disks wear out and are worn off at the end of the outer segment, to be consumed and recycled by phagocytic cells.

Distribution

While rods outnumber cones in most parts of the retina, the fovea, responsible for sharp central vision, consists almost entirely of cones. The distribution of photoreceptors in the retina is called the retinal mosaic, which can be determined using photobleaching. This is done by exposing dark-adapted retina to a certain wavelength of light that paralyzes the particular type of cone sensitive to that wavelength for up to thirty minutes from being able to dark-adapt, making it appear white in contrast to the grey dark-adapted cones when a picture of the retina is taken. The results illustrate that S cones are randomly placed and appear much less frequently than the M and L cones. The ratio of M and L cones varies greatly among different people with regular vision (e.g. values of 75.8% L with 20.0% M versus 50.6% L with 44.2% M in two male subjects).

Sign in to keep reading

2 more chapters are free with a Lably account.

More in Biology