Explosive lens

Use in nuclear weapons

In a nuclear weapon, an array of explosive lenses is used to change the several approximately spherical diverging detonation waves into a single spherical converging one. The converging wave is then used to collapse the various shells (tamper, reflector, pusher, etc.) and finally compresses the core (pit) of fissionable material to a prompt critical state. They are usually machined from a plastic bonded explosive and an inert insert, called a wave-shaper, which is often a dense foam or plastic, though many other materials can be used. Other, mainly older explosive lenses do not include a wave shaper, but employ two explosive types that have significantly different velocities of detonation (VoD), which are in the range from 5 to 9 km/s. The use of the low- and high-speed explosives again results in a spherical converging detonation wave to compress the physics package. The original Gadget device used in the Trinity test and Fat Man dropped on Nagasaki used Baratol as the low-VoD explosive and Composition B as the fast, but other combinations can be used.

The illustration to the left represents a cross section through a segment of a polygonal wedge. The wedges are fitted together to form a spherical device. The exploding-bridgewire detonator at the far left triggers a semi-spherical detonation wave through the high-speed outer explosive. (It is semi-spherical because the exploding-bridgewire acts as a point-detonator.) As the wave is transferred to the precisely shaped inner explosive, a new spherical wave—centered on the object—is formed. The successful functioning of this device hinges on the simultaneous initiation of the wave in each segment, uniformity and precision in the speed of the wave, and correctness and accuracy in the shape of the interface between the two explosives.

A series of experiments were performed in 1944 and 1945 during the Manhattan Project to develop the lenses for a satisfactory implosion. One of the most important tests was the series of RaLa Experiments.

Initially, a 32 "point" assembly was used (each of which had a pair of exploding-bridgewire detonators).

Later, a 92 "point" assembly was tried, with the objective of obtaining a smaller assembly with improved performance.

Finally, with the success of the Swan test nuclear explosive device, a two "point" assembly became feasible. Swan used an "air lens" system in addition to shaped charges and became the basis of all U.S. successor designs, nuclear and thermonuclear alike, and featured small size, light weight, and exceptional reliability and safety, as well as using the least amount of strategic material of any design.

Other uses

Lenses using alternate design techniques and producing flat "plane wave" outputs are used for high transient pressure physics and materials science experiments.