National Ambient Air Quality Standards

Descriptions

1. Ground level ozone (O₃): Ozone found on the surface-level, also known as tropospheric ozone, is also regulated by the NAAQS under the Clean Air Act. Ozone was originally found to be damaging to grapes in the 1950s. The US EPA set "oxidants" standards in 1971, which included ozone. These standards were created to reduce agricultural impacts and other related damages. Like lead, ozone requires a reexamination of new findings of health and vegetation effects periodically. This aspect necessitated the creation of a US EPA criteria document. Further analysis done in 1979 and 1997 made it necessary to significantly modify the pollution standards.
2. Atmospheric particulate matter
   • PM₁₀, coarse particles: 2.5 micrometers (μm) to 10 μm in size (although current implementation includes all particles 10 μm or less in the standard)
   • PM_2.5, fine particles: 2.5 μm in size or less. Particulate Matter (PM) was listed in the 1996 Criteria document issued by the EPA. In April 2001, the EPA created a Second External Review Draft of the Air Quality Criteria for PM, which addressed updated studies done on particulate matter and the modified pollutant standards done since the First External Review Draft. In May 2002, a Third External Review Draft was made, and the EPA revised PM requirements again. After issuing a fourth version of the document, the EPA issued the final version in October 2004.
3. Lead (Pb): In the mid-1970s, lead was listed as a criteria air pollutant that required NAAQS regulation. In 1977, the EPA published a document which detailed the Air Quality Criteria for lead. This document was based on the scientific assessments of lead at the time. Based on this report (1977 Lead AQCD), the EPA established a "1.5 μg/m³ (maximum quarterly calendar average) Pb NAAQS in 1978." The Clean Air Act requires periodic review of NAAQS, and new scientific data published after 1977 made it necessary to revise the standards previously established in the 1977 Lead AQCD document. An Addendum to the document was published in 1986 and then again as a Supplement to the 1986 AQCD/Addendum in 1990. In 1990, a Lead Staff Paper was prepared by the EPA's Office of Air Quality Planning and Standards (OPQPS), which was based on information presented in the 1986 Lead/AQCD/Addendum and 1990 Supplement, in addition to other OAQPS sponsored lead exposure/risk analyses. In this paper, it was proposed that the Pb NAAQS be revised further and presented options for revision to the EPA. The EPA elected to not modify the Pb NAAQS further, but decided to instead focus on the 1991 U.S. EPA Strategy for Reducing Lead Exposure. The EPA concentrated on regulatory and remedial clean-up efforts to minimize Pb exposure from numerous non-air sources that caused more severe public health risks, and undertook actions to reduce air emissions.
4. Carbon monoxide (CO): The EPA set the first NAAQS for carbon monoxide in 1971. The primary standard was set at 9 ppm averaged over an 8-hour period and 35 ppm over a 1-hour period. The majority of CO emitted into the ambient air is from mobile sources. The EPA has reviewed and assessed the current scientific literature with respect to CO in 1979, 1984, 1991, and 1994. After the review in 1984 the EPA decided to remove the secondary standard for CO due to lack of significant evidence of the adverse environmental impacts. On January 28, 2011, the EPA decided that the current NAAQS for CO were sufficient and proposed to keep the existing standards as they stood. The EPA is strengthening monitoring requirements for CO by calling for CO monitors to be placed in strategic locations near large urban areas. Specifically, the EPA has called for monitors to be placed and operational in CBSA's (core based statistical areas) with populations over 2.5 million by January 1, 2015; and in CBSA's with populations of 1 million or more by January 1, 2017. In addition they are requiring the collocation of CO monitors with NO₂ monitors in urban areas having a population of 1 million for more. As of May 2011 there were approximately 328 operational CO monitors in place nationwide. The EPA has provided some authority to the EPA Regional Administrators to oversee case-by-case requested exceptions and in determining the need for additional monitoring systems above the minimum required. The EPA reports the national average concentration of CO has decreased by 82% since 1980. The last nonattainment designation was deemed in attainment on September 27, 2010. Currently all areas in the US are in attainment.
5. Sulfur oxides (SO_x): SO_x refers to the oxides of sulfur, a highly reactive group of gases. SO₂ is of greatest interest and is used as the indicator for the entire SO_x family. The EPA first set primary and secondary standards in 1971. Dual primary standards were set at 140 ppb averaged over a 24-hour period, and at 30 ppb averaged annually. The secondary standard was set at 500 ppb averaged over a 3-hour period, not to be exceeded more than once a year. The most recent review took place in 1996 during which the EPA considered implementing a new NAAQS for 5-minute peaks of SO₂ affecting sensitive populations such as asthmatics. The Agency did not establish this new NAAQS and kept the existing standards. In 2010 the EPA decided to replace the dual primary standards with a new 1-hour standard set at 75 ppb. On March 20, 2012, the EPA "took final action" to maintain the existing NAAQS as they stood. Only three monitoring sites have exceeded the current NAAQS for SO₂, all of which are located in the Hawaii Volcanoes National Park. The violations occurred between 2007–2008 and the state of Hawaii suggested these should be exempt from regulatory actions due to an 'exceptional event' (volcanic activity). Since 1980 the national concentration of SO₂ in the ambient air has decreased by 83%. Annual average concentrations hover between 1–6 ppb. Currently all ACQR's are in attainment for SO₂.
6. Nitrogen oxides (NO_x): The EPA first set primary and secondary standards for the oxides of nitrogen in 1971. Among these are nitric oxide (NO), nitrous oxide (N₂O), and nitrogen dioxide (NO₂), all of which are covered in the NAAQS. NO₂ is the oxide measured and used as the indicator for the entire NO_x family as it is of the most concern due to its quick formation and contribution to the formation of harmful ground level ozone. In 1971 the primary and secondary NAAQS for NO₂ were both set at an annual average of 0.053 ppm. The EPA reviewed this NAAQS in 1985 and 1996, and in both cases concluded that the existing standard was sufficient. The most recent review by the EPA occurred in 2010, resulting in a new 1-hour NO₂ primary standard set at 100 ppb; the annual average of 0.053 ppm remained the same. Also considered was a new 1-hour secondary standard of 100 ppb. This was the first time the EPA reviewed the environmental impacts separate from the health impacts for this group of criteria air pollutants. Also, in 2010, the EPA decided to ensure compliance by strengthening monitoring requirements, calling for increased numbers of monitoring systems near large urban areas and major roadways. On March 20, 2012, the EPA "took final action" to maintain the existing NAAQS as they stand. The national average of NO_x concentrations has dropped by 52% since 1980. The annual concentration for NO₂ is reported to be averaging around 10–20 ppb, and is expected to decrease further with new mobile source regulations. Currently all areas of the US are classified as in attainment.

In April 2023, the EPA finalized its "Good Neighbor Plan", which phases in tighter standards for NO_x, using a cap and trade system during the summer "ozone season". This is intended to reduce ground-level ozone in non-attainment areas downwind of industrial sources like power plants, incinerators, and industrial furnaces, often in other states.

Standards

The standards are listed in 40 CFR 50. Primary standards are designed to protect human health, with an adequate margin of safety, including sensitive populations such as children, the elderly, and individuals suffering from respiratory diseases. Secondary standards are designed to protect public welfare, damage to property, transportation hazards, economic values, and personal comfort and well-being from any known or anticipated adverse effects of a pollutant. A district meeting a given standard is known as an "attainment area" for that standard, and otherwise a "non-attainment area".

Standards are required to "accurately reflect the latest scientific knowledge," and are reviewed every five years by a Clean Air Scientific Advisory Committee (CASAC), consisting of "seven members appointed by the EPA administrator."

EPA has set NAAQS for six major pollutants listed as below. These six are also the criteria air pollutants.

• ^aAs of June 15, 2005, the 1-hour ozone standard no longer applies to areas designated with respect to the 8-hour ozone standard (which includes most of the United States, except for portions of 10 states).
• Source: USEPA

Detection methods

The EPA National Exposure Research Laboratory can designate a measurement device using an established technological basis as a Federal Reference Method (FRM) to certify that the device has undergone a testing and analysis protocol, and can be used to monitor NAAQS compliance. Devices based on new technologies can be designated as a Federal Equivalent Method (FEM). FEMs are based on different sampling and/or analyzing technologies than FRMs, but are required to provide the same decision making quality when making NAAQS attainment determinations. Approved new methods are formally announced through publication in the Federal Register. A complete list of FRMs and FEMs is available.

Air quality control region

An air quality control region is an area, designated by the federal government, where communities share a common air pollution problem.